Hi I used PO_ResetIdentifier with faces set to yes. The result looks like you should have a closer look at this command? A result like Face 5 Face 5_1 Face 5_2 … … may causes less headache I guess :wink: [grafik]

Hi @martin6 , You should always run the PO_ResetBoundaryCondition and PO_ResolveAdjacency commands after running the PO_ResetIdentifier. The error that you get is because you have solved the adjacencies once and then used the PO_ResetIdentifier command which changes the IDs.

Just tried to recreate the issue with a simple model. But there is everything fine and working. Maybe it was caused by the complex model I was referring to in the first post. Had to change rooms and deal a bit with small faces. After stepping back and renaming from scratch the model finally became…

Thank you @mostapha , just tried PO_ResetBoundaryCondition and PO_SolveAdjacency on the backuped file. It works just fine…

Pollination Discourse

PO_ResetIdentifier, faces set to yes, causes trouble

Rhino Plugin

bug-report

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled